Did your TV stop working and you are not sure if it is the lamp? Did you install a new lamp and your TV is not working properly? View
our troubleshooting/repair guide to help you identify the problem.
Just click on button above to begin the guide. We hope you will find this helpful.
the lamp only and replacing the bad lamp in your existing housing is a
very cost effective way that can save you up to hundreds of dollars.
The lamp installation is simple and takes only minutes to complete. The
plastic housing surrounding
the lamp is completely reusable. Picture quality and brightness will
not be affected by reusing the housing. We can safely say that because
we have thoroughly tested this
on every lamp we give advice on. If you do purchase the complete lamp
in housing you should have your old lamp housing recycled because it
contains mercury. It is also against many state laws to throw this
product in the trash. It is highly recommended when you purchase a
lamp replacement to buy a factory original OEM
(original equipment manufacturer) lamp. The two manufacturers of lamps
that TV companies use are Osram and Philips. Some
companies may debate
that Philips lamps are better than Osram or vice versa, but that is
only opinion (or sales tactics) as there are no statistics proving
one is better than the other. We have extensively tested (over 25,000
testing hours) each brand and neither
performs better or lasts longer than the other. Purchasing a lamp
any other brand is an "OEM compatible", generic, or aftermarket lamp
(DNGO, APO). This is not advised because these lamps have a fraction
of the lamp life and can possibly damage your TV.
Detailed written instructions of the lamp installation are for provided below showing how to replace the lamp in the TS-CL110UAA housing.
Please use the included latex-free glove when handling the
lamp.Failure to use the glove during
handling may reduce the life of the lamp.The TV must be unplugged from the outlet before removal of the
lamp.It must stay unplugged until you
are completely finished.
door is located behind a speaker cover on the front left side of the TV.Remove the left speaker cover to expose the
lamp door.The lamp is behind the lamp
four screws on each corner of the housing to remove that will allow the housing
to split in two.Remove the old lamp and
replace it with the new one.Put the
lamp connector in the same position as the old one.
the top of the housing and guide the metal mounting screws through the holes
provided in the housing.Reinstall the
four previously used screws to secure the housing together again.
reinstalling your lamp into the TV, completely reassemble the TV.All lamp doors or anything else removed to
remove the lamp from the TV must be replaced before plugging the TV back in and
turning on.Failure to do so will not
allow the TV to turn on properly.
Reset Procedure:Use the “Lamp Timer
Reset” option in the TV menu.